It is currently Thu Aug 13, 2020 2:48 pm


Post a new topicPost a reply Page 1 of 1   [ 2 posts ]
Author Message
 Post subject: Dirt inside cyclone assembly
PostPosted: Sat Apr 11, 2020 12:47 am 

Joined: Sat Apr 11, 2020 12:43 am
Posts: 1
Dyson model: multifloor 2
Hi - There is a lot of dirt inside my cyclone assembly - I have a Multifloor 2. Is there a way to clean it out? Just to be clear - I'm talking about the assembly not the filter, which I can remove and clean easily. This dirt can be seen through the fine mesh screen on the assembly itself. Thanks


Top
 Profile  
 
 Post subject: Re: Dirt inside cyclone assembly
PostPosted: Wed Apr 22, 2020 6:10 pm 

Joined: Wed Jun 27, 2018 4:33 pm
Posts: 117
Dyson model: v6 fluffy
Hi, the best way to clean this is to take the clear bin off the cyclone. Place the cyclone in a bag and seal the top with your hand to stop dust coming out. You can then give the cyclone a gentle tap on the floor. Dust will fall from the inside of the cyclone into the bag. Not all the dust will be removed as there are many nooks and crannies for the dust to hide inside.

Unless you fully strip the cyclone down you will not clean it 100%. Some people use an airline, you can do this but beware that a lot of dust will be blown into the air!

Even after cleaning, after a few uses the cyclone will get to be in the same condition again as before.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post a new topicPost a reply Page 1 of 1   [ 2 posts ]


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  



The Unofficial Dyson Forum is in no way affiliated with Dyson Ltd.
NO SEO MAIL PLEASE : admin@dysonforum.com
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
twilightBB Style by Daniel St. Jules of Gamexe.net